add: SOP-8_5.28x5.23mm_P1.27mm

• A screenshot of the model(s) aligned with KiCad footprint(s)
• Source files are contributed on the apropriate location
  • Link to the package3d-source pull request or to the script pull request
• Step model submitted in 1:1 scale
• WRL model submitted in 1:2.54 scale
• 3D model alignment checked against KiCad footprint
• WRL model uses correct material properties
• Geometry check performed on the model

---

Based on this datasheet (8-pin SOP (200mil)): https://www.mxic.com.tw/Lists/Datasheet/Attachments/8983/MX25V16066,%202.5V,%2016Mb,%20v1.5.pdf

Generator MR: kicad-packages3D-generator!198

I'm assuming the generator scripts from kicad-packages3D-generator emit the Step and WRL models with the right scales and WRL model properties.

Inspecting the model in KiCad visually and spinning it around in the preview, it does look like the footprint is aligned to the model (see the screenshot).

In terms of dimensions, I'm not great at using FreeCAD to check them, but from the little I can measure, they seem to match the datasheet:

Any other dimensions I should check? I'm not sure how to confirm the angle of the leg.