Samtec FSI One-Pice Interface, 1mm Pitch Connector Series (generated footprints)
This MR adds the definitions for Samtec's FSI 1mm pitch one-pice compression connector series.
A description of the series including the available variants can be found here:
- https://suddendocs.samtec.com/catalog_english/fsi06_10.pdf
- https://suddendocs.samtec.com/catalog_english/a-fsi03_06_10.pdf
This MR adds only the following variants:
- FSI-1XX-XX-X-D
- FSI-1XX-XX-X-D-AD
- FSI-1XX-XX-X-D-M
- FSI-1XX-XX-X-D-M-AD
Footprint Generator MR:
Datasheet:
- 3mm height version:
- 6mm and 10mm height version:
- Footprint-only mates: https://suddendocs.samtec.com/prints/fsi-mating%20board.pdf
Generated Footprints:
Variants without threads: 2 x 5, 2x10, 2 x 15, ..., 2 x 50 positions
- Samtec_FSI-1XX-03-X-D: 3mm height
- Samtec_FSI-1XX-XX-X-D: 6mm or 10mm height
- Samtec_FSI-1XX-03-X-D-AD: 3mm height, with alignment pins
- Samtec_FSI-1XX-XX-X-D-AD: 6mm or 10mm height, with alignment pins
Variants with threads: 2x10, 2 x 20, ..., 2 x 50 positions
- Samtec_FSI-1XX-03-X-D-M: 3mm height, with threads
- Samtec_FSI-1XX-XX-X-D-M: 6mm or 10mm height, with threads
- Samtec_FSI-1XX-03-X-D-M-AD: 3mm height, with threads and alignment pins
- Samtec_FSI-1XX-XX-X-D-M-AD: 6mm or 10mm height, with threads and alignment pins
KLC Violations:
- F6.3 Pad requirements for SMD footprints: the PCB Mate pads do not have Paste as they are compression-only-footprints (no soldering)
-
F5.4 Elements on the graphic layer should not overlap: this is due to the pin-1-marker triangle on the Fab layer; would need to be fixed in the connector generator; but probably not just a one-liner.Fixed by kicad-footprint-generator!1054 (merged)
Screenshot Examples:
Edited by Armin Schoisswohl