Rework Lumberg 1503-07 THT audio jack
Mostly minor KLC updates:
- Remove silk screen where overhangs could occur (F5.1.8)
- Rotate fab res des to long axis (F5.4.b)
- Break silk lines to stay 0.2mm from NPTHs
Geometry changes:
- Tighten courtyard all around
- Move T pins apart by 0.2mm (DS says these are 6.7 to hole edges)
Before:
After:
There isn't a 3D model that I can find to use here.
The 6.7mm was noted in the original MR ( !2595 (merged)) for this part but I think it was mistakenly changed to 6.5mm when the body was also changed to 6.5.
Land pattern drawing:
Body drawing:
KLC viaolations:
- F7.2 origin not at pin 1: there is no pin 1, the pins are T, R, S
Edited by John Beard