Add Texas_X2SON-5_0.8x0.8mm_P0.48mm
Generated using FreeCad and StepUp, with cleanup in the footprint editor. StepUp doesn't support rotated roundrect pads, so I replaced the center pad with a roundrect pad instead of the generated polygon.
FreeCad source is included in MR.
Datasheet: https://www.ti.com/lit/ds/symlink/sn74lvc1g17.pdf#page=39
This symbol is needed for a handful of TI's Little Logic products (74xGxx) including the LVC1G17. (Semi-)related issue: kicad-symbols#3199 (closed)
Additional recommendations taken from TI's guide, Designing and Manufacturing with TI's X2SON Packages https://www.ti.com/lit/an/scea055/scea055.pdf
The TI guide recommends 0.102mm via in center, with .305mm annular ring diameter. This breaks some KLC rules, but I think it's fine.
Edited by Dash Peters