Unassigned interfaces and packet engine stopped in sensei
my hardware/software:
- QOTOM Q575G6 Intel 7 Th Gen Core i7 prozessor 6 x Intel I211-AT Gigabit LAN 16G DDR4 RAM Intel(R) Core(TM) i7-7500U CPU @ 2.70GHz (4 cores)
- OPNsense 19.7.8-amd64
- FreeBSD 11.2-RELEASE-p16-HBSD
- OpenSSL 1.0.2t 10 Sep 2019
sensei:
- Maschine Version: 1.2.4
- UI Version: 19.12.28
- Database Version: 1.3.1
- Licence: Home Edition
Network-config in OPNsense: Interfaces: Overview
-
LAN interface (opt2, lagg1) LAGG Protocol loadbalance lagghash l2,l3,l4 LAGG Ports igb0 igb2
-
LAN_WAN_BRIDGE interface (opt3, bridge0)
-
MGMT interface (lan, igb1)
-
WAN interface (opt1, lagg0) LAGG Protocol loadbalance lagghash l2,l3,l4 LAGG Ports igb3 igb4 igb5
-
Firewall: NAT: Outbound Disable outbound NAT rule generation (outbound NAT is disabled)
-
System: Settings: Tunables net.link.bridge.pfil_member Set to 0 to disable filtering on the incoming and outgoing member interfaces. net.link.bridge.pfil_bridge Set to 1 to enable filtering on the bridge interface
Interface Selection in sensei:Configuration
-
Deployment Mode Routed mode (L3 mode)
-
Available Interfaces on the left side: MGMT (igb1)
-
Protected Interfaces on the right side: Unassigned (igb0) Unassigned (igb2) Unassigned (igb3) Unassigned (igb4) Unassigned (igb5)
i don't understand this: why are the 5 interfaces unassigned in sensei and only the management interface igb1 is assigned? i can not configure a L2 Bridge because i can not select my LAN_WAN_BRIDGE and my lagg devices for WAN and LAN
in suricata under Services: Intrusion Detection: Administration i can see the interfaces:
- LAN
- LAN_WAN_BRIDGE
- MGMT
- WAN
- [igb0]
- [igb2]
- [igb3]
- [igb4]
- [igb5]
how i can configure the bridge mode successfully in sensei?
at the moment the sensei packet ingine stop working - Sensei: Status
Sensei Packet Engine Stopped
regards
joh