Improve documentation and accessories for infinity corrected optics module
There is no proper instructions on how to adjust the microscope for a infinite conjugate objective. It is mentioned in the customisations and alternatives, but it could do with a full step by step page on what to print and how to check the optics module is in focus.
Focusing is an issue, see #158 and this forum thread. I think it make sense to provide camera shims in the accessories, and then to add shimming instructions.
-
Add a page to the instructions describing -
What to print -
How to check focus and adjust with shims
-
-
Add camera shims to the accessory STLs -
Consider updating the optics module itself