Change: Add new PCB design
Add new KiCAD design. This new design adds a couple of interesting features, but should be fully backwards compatible.
New features include support for 2 temperature/humidity sensors.
The DHT11 sensor has been added supplementing/instead of the DS18. Either sensor could be mounted remotely over a wire, though the DHT11 with its 2.54mm pitch is nicer to mount a connector on.
The I2C bus has been exposed on a RJ45 connector and can optionally be used with a differential driver chip.
Two GPIO's are routed to the RJ45 connector, which can be used as I/O or One-Wire bus. Its all in the software.
On the RJ45 there are various options for supplying power. 12v, 5v, 4v3 via a diode, 3v6 via two diodes or 3v3 from the Wemos.
- CI: Add GitLab KiCad pipeline
- gitignore: Ignore KiBot generated temporary files
- kici: Add KiCi submodule for KiBot jobs
- kicad: Add new PCB design
- CI: Use git compatible worksheet
- git: Enable LFS for PDF files
- editorconfig: Add initial .editorconfig
- gitignore: Ignore editor related files
- license: Switch to AGPL-3+ license
- boyscout: Remove generateable files
Edited by Olliver Schinagl