Skip to content

Adds: SC-74 and SC-74A-5

R R requested to merge (removed):add/SOT-25 into master

Thanks for creating a pull request to contribute to the KiCad libraries! Remember you must be the legal owner of the 3D model! Models downloaded from a manufacturers website cannot be accepted.

To speed up integration of your PR, please check the following items as you complete them:

SC-74A-5

  • A screenshot of the model(s) aligned with KiCad footprint(s) Taken on footprint SC-74A-5_1.55x2.9mm_P0.95mm. image
  • Source files are contributed on the apropriate location: Link here
  • Step model submitted in 1:1 scale
    • Submitted based on 3D generator output
  • WRL model submitted in 1:2.54 scale
    • Submitted based on 3D generator output
  • [] 3D model alignment checked against KiCad footprint Covered above
  • WRL model uses correct material properties
    • I'll assume so. It uses the automated 3D packages, so it uses the same material properties as the rest of the gullwing/SOT packages.
  • Geometry check performed on the model
    • What is a geometry check? I generated the model with the 3D models generator and was quite diligent with the model parameters.

SC-74

  • A screenshot of the model(s) aligned with KiCad footprint(s) Taken on footprint SC-74-6_1.55x2.9mm_P0.95mm. image
  • Source files are contributed on the apropriate location: Link here
  • Step model submitted in 1:1 scale
    • Submitted based on 3D generator output
  • WRL model submitted in 1:2.54 scale
    • Submitted based on 3D generator output
  • [] 3D model alignment checked against KiCad footprint Covered above
  • WRL model uses correct material properties
    • I'll assume so. It uses the automated 3D packages, so it uses the same material properties as the rest of the gullwing/SOT packages.
  • Geometry check performed on the model
    • What is a geometry check? I generated the model with the 3D models generator and was quite diligent with the model parameters.

Be patient, we maintainers are volunteers with limited time and need to check your contribution against the datasheet. You can speed up the process by providing all the necessary information (see above).

Edited by R R

Merge request reports