Kycon_KDMIX-SL1-NS-WS-B15 - minor fixes
- Retract silkscreen from nominal board edge
- Adjust round rect radius -> 0.25mm
- Rotate to pin 1 at top left
- Add pin 1 marker visible after assembly
- Kicad 6 -> 7 in model path
- Fab layer pin 1 marker (chevron pointing at pin 1)
I also zeroed the model offset, but I assume that was set to match the manufacturer STEP. So not sure about if that's a good idea.
Original Github PR: https://github.com/KiCad/kicad-footprints/pull/1651
KLC check: annulus size 0.125mm, not changed (justification in the original PR).
Edited by John Beard