Uncaught Design Rule Violation: Minimum annular ring on through-hole pads
Description
Design rules for minimum annular ring are not obeyed for plated through-hole pads.
Steps to reproduce
- Make a pad with hole 0.9mm and circular pad size of 1.0mm (annular width of 0.05mm)
- Set Board Setup->Design Rules->Constraints->Minimum Annular Width to 0.2mm
- Run Inspect->Design Rules Checker
- No issue found at pad with annular width 0.05mm
I've seen this issue described in kicad forums back in 2016, but not in other issues in here in kicad GitLab.
KiCad Version
Application: KiCad PCB Editor (64-bit)
Version: (6.0.5-4-g4e13677281), release build
Libraries:
wxWidgets 3.1.5
libcurl/7.82.0-DEV Schannel zlib/1.2.12
Platform: Windows 10 (build 19043), 64-bit edition, 64 bit, Little endian, wxMSW
Build Info:
Date: May 4 2022 05:10:31
wxWidgets: 3.1.5 (wchar_t,wx containers)
Boost: 1.79.0
OCC: 7.6.0
Curl: 7.82.0-DEV
ngspice: 36
Compiler: Visual C++ 1929 without C++ ABI
Build settings:
KICAD_USE_OCC=ON
KICAD_SPICE=ON
Edited by KiCad Bot