... | ... | @@ -24,7 +24,7 @@ TODO: **WIP** Make the descriptions in the table shorter, but include a much mor |
|
|
| modeline_generation | Enable on-the-fly generation of video modes | `0` or `1` | Linux & Windows |
|
|
|
| interlace | Allow interlaced modes (existing or generated) | `0` or `1` |Linux & Windows |
|
|
|
| doublescan | Allow doublescan modes (warning: doublescan support is broken in most drivers) | `0` or `1` | Linux & Windows |
|
|
|
| [dotclock_min](https://gitlab.com/groovyarcade/support/-/wikis/3-Post-Installation-and-Maintenance/3.9-Configure-System-Wide-Switchres#minimum-dot-clock) | Force a minimum dotclock value, in MHz, e.g. dotclock_min 25.0 | integer 0-? | Linux & Windows |
|
|
|
| [dotclock_min](https://gitlab.com/groovyarcade/support/-/wikis/3-Post-Installation-and-Maintenance/3.9-Configure-System-Wide-Switchres#minimum-dot-clock) | Force a minimum dotclock value, in MHz, e.g. dotclock_min 25.0 | float 0-? | Linux & Windows |
|
|
|
| sync_refresh_tolerance | Maximum refresh difference, in Hz, allowed in order to synchronize. Below this value, the mismatch does not involve penalization | integer 0-? | Linux & Windows
|
|
|
| super_width | Super resolution width: above this width, fractional scaling on the horizontal axis is applied without penalization | integer ?-? common values: `1920` or `2560` | Linux & Windows |
|
|
|
| aspect | Physical aspect ratio of the target monitor. Used to compensate aspect ratio when the target monitor is not 4:3 | common values: `4:3` or `16:9` or `16:10` | Linux & Windows |
|
... | ... | |