... | ... | @@ -125,17 +125,17 @@ NEW in v0.2 |
|
|
* The HAT attacheds to the pi via the long double row of pins.
|
|
|
* Simply align the pins (with the HAT on top) and push them together
|
|
|
1. Wire Motors to HAT
|
|
|
* Requires 10 cm (or shorter) adafruit (MALE to MALE) jumper cables
|
|
|
* example: https://www.amazon.com/EDGELEC-Breadboard-Optional-Assorted-Multicolored/dp/B07GD2BWPY/ref=sr_1_3?dchild=1&keywords=raspberry+pi+jumper+wires&qid=1587918517&sr=8-3
|
|
|
* The HAT has two rows of 5 connections, with labels M1, M2, M3, and M4
|
|
|
* In the 5 connections, the first and last two are the connections to the motor while the center connection is the ground
|
|
|
* Plug 4 of the jumper cables into the connections for the motor (add tape to ensure secure connection)
|
|
|
* Requires 10 cm (or shorter) adafruit (MALE to MALE) jumper cables
|
|
|
* example: https://www.amazon.com/EDGELEC-Breadboard-Optional-Assorted-Multicolored/dp/B07GD2BWPY/ref=sr_1_3?dchild=1&keywords=raspberry+pi+jumper+wires&qid=1587918517&sr=8-3
|
|
|
* The HAT has two rows of 5 connections, with labels M1, M2, M3, and M4
|
|
|
* In the 5 connections, the first and last two are the connections to the motor while the center connection is the ground
|
|
|
* Plug 4 of the jumper cables into the connections for the motor (add tape to ensure secure connection)
|
|
|
* For the first motor,
|
|
|
* the first two cables should go into the two slots under M1
|
|
|
* the second two should go into the two slots under M2 (leaving the middle ground port vacant)
|
|
|
* the first two cables should go into the two slots under M1
|
|
|
* the second two should go into the two slots under M2 (leaving the middle ground port vacant)
|
|
|
* For the second motor,
|
|
|
* the first two cables should go into the two slots under M3
|
|
|
* the second two should go into the two slots under M4 (leaving the middle ground port vacant)
|
|
|
* the first two cables should go into the two slots under M3
|
|
|
* the second two should go into the two slots under M4 (leaving the middle ground port vacant)
|
|
|
* The cables are secured to the HAT by tightening the screws at the top of the connections
|
|
|
|
|
|
1. Slide screen into electronics housing and connect screen USB and HDMI to pi
|
... | ... | |