Installation went fine on Pi 4 (Raspberry Pi OS Lite) but service won't start?
Description of my Issue:
Installation went fine but service wont' start. Already rebooted the system. When I run
pi@Raspberry-Pi:~ $ argonone-cli --verbose --decode
ERROR: argononed is not running, or has no shared memory access
Service isn't started and won't start (stuck after issuing the following command):
pi@Raspberry-Pi:~ $ sudo systemctl start argononed.service
pi@Raspberry-Pi:~ $ sudo systemctl status argononed.service
● argononed.service - Argon One Fan and Button Daemon Service
Loaded: loaded (/etc/systemd/system/argononed.service; enabled; vendor preset: enabled)
Active: inactive (dead)
Command i2cset -y 1 0x01a 10
seems to work fine, I can hear the fan spinning at its maximum.
___ __
/ | _________ _____ ____ ____ ____ ___ ____/ /
/ /| | / ___/ __ `/ __ \/ __ \/ __ \/ __ \/ _ \/ __ /
/ ___ |/ / / /_/ / /_/ / / / / /_/ / / / / __/ /_/ /
/_/ |_/_/ \__, /\____/_/ /_/\____/_/ /_/\___/\__,_/
/____/
_________________________________________________________
>>> Reset build to mrproper...
removed 'build/argonone-cli'
removed 'build/argonone-shutdown'
removed 'build/argonone.dtbo'
removed 'build/argononed'
removed 'build/argononed.o'
removed 'build/event_timer.o'
removed 'makefile.conf'
>>> Running prebuild configuration...
ARGON ONE DAEMON CONFIGURING ...
Distro check [debian] : OK
SYSTEM CHECK
gcc : OK
dtc : OK
make : OK
I2C Bus check : ENABLED
CHECKING OPTIONAL SYSTEMS
bash-autocomplete : OK
logrotate : INSTALLED
Dependency Check : Successful
>>> Building...
Compile src/argononed.c
gcc -c -o build/argononed.o src/argononed.c -Wall -s -O3 -DLOG_LEVEL=5
Compile src/event_timer.c
gcc -c -o build/event_timer.o src/event_timer.c -Wall -s -O3 -DLOG_LEVEL=5
Build argononed
gcc -o build/argononed build/argononed.o build/event_timer.o -Wall -s -O3 -lpthread -lrt
Build argonone-shutdown
gcc -o build/argonone-shutdown src/argonone-shutdown.c -Wall -s -O3
MAKE: Daemon
Build argonone-cli
gcc -o build/argonone-cli src/argonone-cli.c -Wall -s -O3 -DLOG_LEVEL=5 -lrt
MAKE: CLI
Build argonone.dtbo
dtc -@ -I dts -O dtb -o build/argonone.dtbo src/argonone.dts
MAKE: Overlay
MAKE: Complete
>>> Installing...
Installing overlay Successful
search /boot/config.txt for overlay ... NOT FOUND
insert overlay into /boot/config.txt ... DONE
Check for module i2c-dev FOUND
Installing daemon Successful
Installing CLI Successful
Installing CLI autocomplete for bash Successful
Installing services
argononed.service ... Successful
argonone-shutdown ... Successful
Refresh services list
Enable Service Successful
Starting Service Successful
Install Complete
Created symlink /etc/systemd/system/multi-user.target.wants/argononed.service → /etc/systemd/system/argononed.service.
Details about my setup:
- Model: PI4 B 4Gb
- OS: Raspberry Pi OS Lite 64bit
- Kernel: Linux Raspberry-Pi 5.15.61-v8+ #1579 SMP PREEMPT Fri Aug 26 11:16:44 BST 2022 aarch64 GNU/Linux