postinstall.rst 2.66 KB
Newer Older
Jean-Yves LEBLEU's avatar
Jean-Yves LEBLEU committed
1
*****************
2
Post Installation
Jean-Yves LEBLEU's avatar
Jean-Yves LEBLEU committed
3 4
*****************

5 6 7
Here are a few configuration options that are commonly changed once the installation is completed.
Please note that these changes are optional.

Pascal Cadotte Michaud's avatar
Pascal Cadotte Michaud committed
8

9 10 11
Display called name on internal calls
=====================================

12 13 14
.. note:: Configured by default if you checked the *Apply default onfiguration for France* at the wizard time
          (see :ref:`Wizard configuration step <wizard_configuration>`).

15 16 17 18 19 20 21 22 23 24
When you call internally another phone of the system you would like your phone to display the name
of the called person (instead of the dialed number only).
To achieve this you must change the following SIP options:

* :menuselection:`Services --> IPBX --> General settings --> SIP Protocol --> Default`:

    * Trust the Remote-Party-ID: yes,
    * Send the Remote-Party-ID: select ``PAI``


25 26
.. _callerid_num_normalization:

27 28 29
Incoming caller number display
==============================

30
The caller ID number on incoming calls depends on what is sent by your operator.
Sebastien Duthil's avatar
Sebastien Duthil committed
31
You can modify it via the file :file:`/etc/xivo/asterisk/xivo_in_callerid.conf`.
32

33 34
.. note:: The reverse directory lookup use the caller ID number after it has been modified by
          :file:`xivo_in_callerid.conf`
35 36 37

Examples:

38 39
* If you use a prefix to dial outgoing numbers (like a 0) you should add a 0 to all the ``add =`` sections,
* You may want to display incoming numbers in E.164 format. For example, you can change the ``[national1]`` section to::
40 41 42 43 44

    callerid = ^0[1-9]\d{8}$
    strip = 1
    add = +33

45
To enable the changes you have to restart xivo-agid::
46 47 48 49 50 51 52

    service xivo-agid restart


Time and date
=============

53
* Configure your locale and default time zone device template => :menuselection:`Configuration --> Provisioning --> Template Device`
Jean-Yves LEBLEU's avatar
Jean-Yves LEBLEU committed
54
  by editing the default template
55 56
* Configure the timezone in => :menuselection:`Services --> IPBX --> General settings --> Advanced --> Timezone`
* If needed, reconfigure your timezone for the system::
57 58

    dpkg-reconfigure tzdata
59 60 61 62 63


Codecs
======

64 65 66
.. note:: Configured by default if you checked the *Apply default onfiguration for France* at the wizard time
          (see :ref:`Wizard configuration step <wizard_configuration>`).

67
You should also select default codecs. It obviously depends on the telco links, the country, the phones, the usage, etc.
68
Here is a typical example for Europe (the main goal in this example is to select *only* G.711 A-Law instead of both G.711 A-Law and G.711 碌-Law by default):
69 70 71

* SIP : :menuselection:`Services --> IPBX --> General settings --> SIP Protocol --> Signaling`:

72
    * Customize codec : enabled
73 74 75 76 77 78 79
    * Codec list::

        G.711 A-Law
        G.722
        G.729A
        H.264