-
r20210104-1338-e3sme3v12-noblt-marlin2072 Release: Marlin 2.0.7.2 for BTT SKR Mini E3 v1.2 WITHOUT BLTouch support
-
-
r20201231-1153-e3sme3v12-marlin2072 Release: Marlin 2.0.7.2 for BTT SKR Mini E3 v1.2 with BLTouch support
-
r20200705-1520-e3sme3v12-stexv6-marlin2053-bugfix2 Release: r20200705-1520-e3sme3v12-stexv6-marlin2053-bugfix2
-
r20200620-1131-e3sme3v12-stex-marlin2053-bugfix2 Release: r20200620-1131-e3sme3v12-stex-marlin2053-bugfix2
-
-
r20200427-1520-e3sme3v12-stex-marlin2053-bugfix1 Release: r20200427-1520-e3sme3v12-stex-marlin2053-bugfix1
-
-
-
-
-
-
-
r20200111-2101-e3sme3v12 Release: r20200111-2101-e3sme3v12
Installation: Insert it into your mainboard Turn your Ender 3 on (or restart it) It can take up to 30 seconds for the new firmware to load Features: Marlin 2.0.1 + bugfixes Manual mesh bed leveling Thermal runaway protection TMC2209 by default (SKR mini E3 V1.2) No boot splash (for faster booting) Faster homing SpreadCycle only kicks in at high speeds (StealthChop by default) Preheat PLA and PETG (no ABS) Filament change/load/unload Hot end auto park (e. g. when print finishes) No beep (buzzer is disabled but should still work when thermal runaway protection is triggered) Preconfigured steps/mm for dual gear bowden extruder (simply set it back to 93 if you have standard single gear) Optimal TMC driver current Automatic stepper motor driver current decrease when overheating is detected Various improvements in configuration