Commit 0bca2d65 authored by Kevin Cole's avatar Kevin Cole

- Close in on better values for DEFAULT_AXIS_STEPS_PER_UNIT

parent eb08b129
// Last modified by Ubuntourist <ubuntourist@hacdc.org> 2019.02.14 (kjc)
//
// 2019.02.14 KJC - Enabled EEPROM_SETTINGS and EEPROM_CHITCHAT
// 2019.06.03 KJC - Screwed with DEFAULT_AXIS_STEPS_PER_UNIT
//
#ifndef CONFIGURATION_H
......@@ -329,12 +330,16 @@ const bool Z_ENDSTOPS_INVERTING = true; // true = invert the logic of the endsto
// default settings
#define DEFAULT_AXIS_STEPS_PER_UNIT {100.5,100.5,1600,800} // default steps per unit for ultimaker
#define DEFAULT_MAX_FEEDRATE {500, 500, 10, 45} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {9000,9000,100,10000} // X, Y, Z, E maximum start speed for
// accelerated moves. E default values are
// good for skeinforge 40+, for older
// versions raise them a lot.
// 2019.06.03 KJC - Screwed with DEFAULT_AXIS_STEPS_PER_UNIT
//
//#define DEFAULT_AXIS_STEPS_PER_UNIT {100.5, 100.5, 1600, 800} // default steps per unit for ultimaker
//#define DEFAULT_AXIS_STEPS_PER_UNIT {100.5, 100.5, 200.0 * 8 / 2, 800} // default steps per unit for ultimaker
#define DEFAULT_AXIS_STEPS_PER_UNIT {100.5, 66.67, 200.0 / 2, 800} // default steps per unit for ultimaker
#define DEFAULT_MAX_FEEDRATE {500, 500, 10, 45} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {9000, 9000, 100, 10000} // X, Y, Z, E maximum start speed for
// accelerated moves. E default values are
// good for skeinforge 40+, for older
// versions raise them a lot.
#define DEFAULT_ACCELERATION 500 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for r retracts
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment