Anchor point locations
Hi again and sorry for bugging you with all the questions. I just came up with a general question about the kinematics where i am not sure how Hangprinter would behave.
Is it possible to build up Hangprinter that way that ABC anchors have a Z coordinate higher (positive value) than the origin 0,0,0 (where the nozzle tips the print platform)? Would it work or is it a must of the kinematics definition that ABC have to be set lower than the origin point?
I came up with that question because i saw a lot of photos of Hangprinters. At the earlier steps you printed that really big Babel tower in the cool stairwell and i believe while doing this it was required to re-adjust the anchor points multiple times by raising them up along some metal beams.
i am also working on some graphics to explain different key measurements and so on. One of my drawings looks like this at the moment: