Commit 81495a94 authored by Radford Neal's avatar Radford Neal

date change in NEWS and INSTALL

parent f7e4ba38
...@@ -20,8 +20,8 @@ described below, and in the R-admin manual. ...@@ -20,8 +20,8 @@ described below, and in the R-admin manual.
Configuring pqR Configuring pqR
After uncompressing and unpacking the tar archive (with a command such After uncompressing and unpacking the tar archive (with a command such
as "tar xf pqR-2014-09-28.tar.gz"), you should make a directory in as "tar xf pqR-2014-09-30.tar.gz"), you should make a directory in
which to build pqR, such as "pqR-2014-09-28-myconfig". It is possible which to build pqR, such as "pqR-2014-09-30-myconfig". It is possible
to instead build pqR in the source directory, but using a separate to instead build pqR in the source directory, but using a separate
directory is preferable, so that the source directory says clean, and directory is preferable, so that the source directory says clean, and
so that you can create more than one configuration if desired. so that you can create more than one configuration if desired.
...@@ -31,7 +31,7 @@ You should then enter the build directory, and issue the command: ...@@ -31,7 +31,7 @@ You should then enter the build directory, and issue the command:
path-to-source-directory/configure path-to-source-directory/configure
where "path-to-source-directory" is the path to the source directory, where "path-to-source-directory" is the path to the source directory,
perhaps something like "../pqR-2014-09-28". perhaps something like "../pqR-2014-09-30".
The configure command will produce a lot of output regarding the The configure command will produce a lot of output regarding the
results of checks for various system facilities, and end (if results of checks for various system facilities, and end (if
......
...@@ -6,7 +6,7 @@ ...@@ -6,7 +6,7 @@
\encoding{UTF-8} \encoding{UTF-8}
\section{CHANGES IN VERSION RELEASED 2014-09-28}{ \section{CHANGES IN VERSION RELEASED 2014-09-30}{
\subsection{INTRODUCTION}{ \subsection{INTRODUCTION}{
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment