Commit 81495a94 authored by Radford Neal's avatar Radford Neal

date change in NEWS and INSTALL

parent f7e4ba38
......@@ -20,8 +20,8 @@ described below, and in the R-admin manual.
Configuring pqR
After uncompressing and unpacking the tar archive (with a command such
as "tar xf pqR-2014-09-28.tar.gz"), you should make a directory in
which to build pqR, such as "pqR-2014-09-28-myconfig". It is possible
as "tar xf pqR-2014-09-30.tar.gz"), you should make a directory in
which to build pqR, such as "pqR-2014-09-30-myconfig". It is possible
to instead build pqR in the source directory, but using a separate
directory is preferable, so that the source directory says clean, and
so that you can create more than one configuration if desired.
......@@ -31,7 +31,7 @@ You should then enter the build directory, and issue the command:
path-to-source-directory/configure
where "path-to-source-directory" is the path to the source directory,
perhaps something like "../pqR-2014-09-28".
perhaps something like "../pqR-2014-09-30".
The configure command will produce a lot of output regarding the
results of checks for various system facilities, and end (if
......
......@@ -6,7 +6,7 @@
\encoding{UTF-8}
\section{CHANGES IN VERSION RELEASED 2014-09-28}{
\section{CHANGES IN VERSION RELEASED 2014-09-30}{
\subsection{INTRODUCTION}{
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment