Commit b6cfffa7 authored by Bhadram Varka's avatar Bhadram Varka Committed by David S. Miller

stmmac: fix DMA channel hang in half-duplex mode

HW does not support Half-duplex mode in multi-queue
scenario. Fix it by not advertising the Half-Duplex
mode if multi-queue enabled.
Signed-off-by: default avatarBhadram Varka <vbhadram@nvidia.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent bc8a2d9b
......@@ -928,6 +928,7 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv)
static int stmmac_init_phy(struct net_device *dev)
{
struct stmmac_priv *priv = netdev_priv(dev);
u32 tx_cnt = priv->plat->tx_queues_to_use;
struct phy_device *phydev;
char phy_id_fmt[MII_BUS_ID_SIZE + 3];
char bus_id[MII_BUS_ID_SIZE];
......@@ -968,6 +969,15 @@ static int stmmac_init_phy(struct net_device *dev)
phydev->advertising &= ~(SUPPORTED_1000baseT_Half |
SUPPORTED_1000baseT_Full);
/*
* Half-duplex mode not supported with multiqueue
* half-duplex can only works with single queue
*/
if (tx_cnt > 1)
phydev->supported &= ~(SUPPORTED_1000baseT_Half |
SUPPORTED_100baseT_Half |
SUPPORTED_10baseT_Half);
/*
* Broken HW is sometimes missing the pull-up resistor on the
* MDIO line, which results in reads to non-existent devices returning
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment