Commit 95b612cc authored by Masahiro Yamada's avatar Masahiro Yamada Committed by Linus Walleij

pinctrl: move CONFIG_PINCTRL to drivers/Makefile

Kbuild should descend into drivers/pinctrl/ only when CONFIG_PINCTRL
is enabled because everything under that directory depends on
CONFIG_PINCTRL.

We can avoid the conditional, ifeq ($(CONFIG_OF),y) ... endif.
Signed-off-by: default avatarMasahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent b3b66163
......@@ -11,7 +11,7 @@ obj-y += bus/
obj-$(CONFIG_GENERIC_PHY) += phy/
# GPIO must come after pinctrl as gpios may need to mux pins etc
obj-y += pinctrl/
obj-$(CONFIG_PINCTRL) += pinctrl/
obj-y += gpio/
obj-y += pwm/
obj-$(CONFIG_PCI) += pci/
......
......@@ -2,12 +2,10 @@
subdir-ccflags-$(CONFIG_DEBUG_PINCTRL) += -DDEBUG
obj-$(CONFIG_PINCTRL) += core.o pinctrl-utils.o
obj-y += core.o pinctrl-utils.o
obj-$(CONFIG_PINMUX) += pinmux.o
obj-$(CONFIG_PINCONF) += pinconf.o
ifeq ($(CONFIG_OF),y)
obj-$(CONFIG_PINCTRL) += devicetree.o
endif
obj-$(CONFIG_OF) += devicetree.o
obj-$(CONFIG_GENERIC_PINCONF) += pinconf-generic.o
obj-$(CONFIG_PINCTRL_ADI2) += pinctrl-adi2.o
obj-$(CONFIG_PINCTRL_AS3722) += pinctrl-as3722.o
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment