Former-commit-id: 638697c74a6e0dcafc42f4a49d076cd61be22866 [formerly e604dc076f5e78b688598ca8c72cbfe4af74e2a2]
Former-commit-id: ef2c065211cdc7ef90cf9f5266e98aac0ab4d0e0
Former-commit-id: c0f83cb6

Former-commit-id: 23b208c742ced518571eb2cb9622656673292ce4 [formerly 4260e2555c5ca04cd7d1de5e11e3ef87a902c60a]
Former-commit-id: 3a2f2018fef3cd0c31a94c612834d3fde8a92ae5
Former-commit-id: d88403b7

The bottom flexures weren’t actually part of the main body - there was
a zero width gap between the flexures and the wall.  This is now fixed.

Also, I added slight indents either side of where the flexures join the
wall to ensure it’s properly retained.


Former-commit-id: b82c1bb478412e072f6729fc3af93684c1b0a0ef [formerly b806cc6d23d401ee3f252cd37a1a0129833a3464]
Former-commit-id: 6cf6d0412e323c1b5eb5536785cefa141dfe9f23
Former-commit-id: 9e3c537c

The sloping-in wall round the microscope body meant the flexures
weren’t attaching (on some printers/slicers) - I’ve now made them go
further in to the body, so they connect properly.


Former-commit-id: 7585eca2f42765c279153ac2d8223c8b399ff39b [formerly 45449058d6155b34640e9bdf09945926d4dc6ec1]
Former-commit-id: c9ebfbf00f493803036593bb34ff99f14a5da4ef
Former-commit-id: 7cee3519

Better photos and improved assembly instructions, including using the
gear riser properly.


Former-commit-id: 63fd60a6439e80fbf766e46f28a3766b7d3dec33 [formerly 3dac85f727a0d2c2e456ab228f445ce97cd79da0]
Former-commit-id: a03e97d45b005d9a2ae7b076ab824eebaf9631cd
Former-commit-id: c64f206b

Former-commit-id: 9c1459bcf51a78316b18b06066efa7530c38079f [formerly d87d0dfce7cfb9f56d6c579d850ee0bb734299da]
Former-commit-id: 3abaf855fec6c2326888d15cdc9a8a8b54e9d9df
Former-commit-id: 37833091

Former-commit-id: 6f4201c99ef3c65bfe871579c3fb7dcb468d9a8c [formerly 967c6f7a2d60744eb717100dccb640a8e7d34a62]
Former-commit-id: 62cde6967dc3df3b06991608b2f99c6854b1abef
Former-commit-id: 16e85094