5mm LED work-around: condenser_LED_holder position
In the 5mm LED workaround instructions, the 5mm LED is held in the condenser lid with the top of the LED recessed slightly into the lid
This allows the instruction:
because there is space for the 0.5mm diffuser
However on building this work-around, my LED sticks out of the lid. This means that it goes through where the diffuser should be.
I have looked at the render of the instructions, and from a different angle the condenser_led_holder part is placed overlapping with the condenser_lid part:
or a little clearer with a different colour
@julianstirling did test this I think, so at some point the cut-out in the condeser_lid must have been made less deep.
- Move the condenser lid cut-out further into the lid
- Check that there is still enough depth in the lid for the screws
- Consider keeping the cable outlet at the current height, or even making it shallower