Skip to content

Illumination mount - Deeper screw pockets in the nut traps

On the Illumination mount above the z-axis actuator: Suggest adding an M3 clearance pocket for the screw to go further through below where the nut is inserted. SharedScreenshot

  • to allow M3x12 screw to be used to pinch the nut into the nut trap without teh illuminator attached. (Currently M3x8 is too short to hold the illumination dovetail reliably, but M3x12 is too long to pinch up teh nut unless the illuminator is fitted)

  • to allow a tolerance for different screw lengths.