Sample clip mounting holes
Created by: jhitesma
Working on building the 5.2 release. Not sure choosing a beta release as my first try was a great decision but figured why not go with the latest and give some feedback - it's only a few hours of printing if I need to do it again.
So far it's going well and I haven't run into any real issues. All the parts printed well and seem to fit well. Finding suitable O-rings in the US has proven a bit difficult. At least at the local level. I found some at McMaster Carr but they won't be here until Monday and the only ones close I found find in town were too thick and either too big or too small so I may try and find some suitable rubber bands in the meantime so I can try it out this weekend.
There is one issue I just found though and that's the holes for the sample clips to screw into. They're too loose. M3 screws go right in and don't bite into the material at all. But the holes in the clips are too small for M4 screws and M4 screws won't fit into the mounting holes either. All the other hole sizes seem correct just these are way loose for me.
Only other feedback so far is that the docs haven't been updated to mention the nut traps for mounting the dovetail to the main body. Nice addition though! Also the estimated print times in the docs seem quite a bit off. The v5.2 main body (with motor mounts since I have a bunch of 28byj steppers laying around) on my Prusa MK3 with prusa's default 0.2mm settings took 10 hours which is about double what the docs estimate.