Commit f14e2cfd authored by Julian Stirling's avatar Julian Stirling 🐧

Tweaking docs

parent 7586bfb5
......@@ -15,9 +15,10 @@ A 3D printed *x-y-z* translation stage.
[main body]: "{cat:3DPrinted}"
[moving platform]: "{cat:3DPrinted}"
[large gears]: "{cat:3DPrinted}"
[small gears]: "{cat:3DPrinted, note: '- Only if using motors'}"
[2.5mm Allen key]: "{cat:tool}"
[light oil]: "{cat:tool}"
![](images/0-1-AllParts.jpg)
......@@ -54,7 +55,7 @@ Take a [large gears]{Qty: 3} and push a [M3x25mm hex head screw]{Qty: 3} into it
![](images/3-4-Washers.jpg)
Start screwing the gear into the actuator column from the top. Apply a small amount of light oil to the screw thread, before you fully tighten the screw
Start screwing the gear into the actuator column from the top. Apply a small amount of [light oil]{Qty: "A few drops of"} to the screw thread, before you fully tighten the screw
![](images/3-5-GearAttach.jpg)
![](images/3-6-Oil.jpg)
![](images/3-7-GearAttach.jpg)
......@@ -116,6 +117,9 @@ Attach the platform to the stage with four [M3x6mm screws][M3x6mm screw]{Qty: 4}
## Attaching motors - Optional
[small gears]: "{cat:3DPrinted, note: '- Only if using motors'}"
[28BYJ-48 micro geared stepper motors]: "{note: '- Only if using motors'}"
Push a [small printed gear][small gears]{Qty: 3} onto each [stepper motor][28BYJ-48 micro geared stepper motors]{Qty: 3}.
Attach motors to the main body such that the gears mesh with the gears on the actuators. Use two [M4x6mm button head screws]{Qty: 6} per motor (requires [2.5mm Allen key]{Qty: 1}) to secure them in place.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment