Optimized settings for netify agent

Hi, since I've been using the Netify agent on the internal network with over 200 devices, the agent seems to get a high CPU workload due to heavy traffic. Are there any optimization or recommended settings for these situations? The agent gets stuck and automatically restarts by the OOM killer. Current netifyd settings are almost in default.

netifyd.conf:

[netifyd]
enable_sink = no
json_save = yes
update_interval = 1

[socket]
listen_path[0] = /var/run/netifyd/netifyd.sock

[protocols]
all=include

netifyd:

# Netify Agent command-line options
# Copyright (C) 2016-2022 eGloo Incorporated
#
# This is free software, licensed under the GNU General Public License v3.
#
# See the netifyd(8) manual for common options.

# Auto-detect (when possible) network ineterface roles (yes/no)?
NETIFYD_AUTODETECT="no"

# Set desired custom options here:
# NETIFYD_EXTRA_OPTS=""

# Define internal network interfaces and if needed, corresponding network
# addresses.  Normally network addresses are discovered via Netlink but for
# cases where Netlink is unavailable or when capturing from a mirrored port,
# they should be specified as a comma-delimited list as shown below:
# NETIFYD_INTNET="eth1 eth2 eth3,192.168.0.0/24,10.0.0.0/16"
NETIFYD_INTNET="eth1"

# Define external network interfaces.  For PPPoE interfaces, you can optionally
# specify the associated physical ethernet interface to set the MAC address.
# NETIFYD_EXTNET="eth4 ppp0,eth5"
NETIFYD_EXTNET="enp0s3"

Process status using htop:

Service log using journalctl: