Commit bd7e56c8 authored by Michael Büsch's avatar Michael Büsch
Browse files

Update README



Signed-off-by: Michael Büsch's avatarMichael Buesch <m@bues.ch>
parent 46297c16
......@@ -3,18 +3,18 @@
--- Fully Open Source CNC remote control device
------
Copyright (c) 2009-2011 Michael Buesch <m@bues.ch>
Copyright (c) 2009-2013 Michael Buesch <m@bues.ch>
--- Integrating CNC-Control into EMC2 ---
--- Integrating CNC-Control into LinuxCNC ---
EMC 2.5.0(-pre) or later is required.
LinuxCNC 2.5.x or later is required.
Integration into EMC2 is easy, because the CNC-Control HAL file is pretty
much selfcontained. Just copy the driver/cnccontrol.hal file to your EMC2
Integration into LinuxCNC is easy, because the CNC-Control HAL file is pretty
much selfcontained. Just copy the driver/cnccontrol.hal file to your LinuxCNC
configuration directory. Then modify your .ini file to load the new .hal file.
EMC2 can load multiple HAL files. So all that is needed usually is to add
LinuxCNC can load multiple HAL files. So all that is needed usually is to add
a line like this
HALFILE = cnccontrol.hal
to the end of the [HAL] section of your .ini file. Add the new HALFILE line
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment