Sidekick 747 color change not able to continue
Sidekick 747 non-LCD SE/SL/HE 2.0.9.0.9 firmware was unable to continue the print after a filament change that was set in Cura. The hot end temp would fluctuate between -8 and +5 of the target temp. Ran a PID tune with the fan at 100% and the issue remained. I was able to get the print to continue but had to remove the blower fan from the tool head to get the temp to stabilize enough to allow it to continue, then reinstall the blower fan. I was printing tethered.