Edge.Cuts defined in Neutrik XLR footprints won't connect with PCB outline and gives DRC error
Raising this as an issue as requested in the discussion forums here: (https://forum.kicad.info/t/edge-cuts-on-connector-audio-jack-xlr-neutrik-nc3fahr-0-horizontal/25973).
The lines defined on the Edge.Cuts layer for Neutrik XLR connectors (I have tried the NC3FAHR-0 and NC3FAHR2-0) do not properly meet the PCB outline defined on the Edge.Cuts layer (v5.1.7-0-10_14 on macOS).
When running the DRC it shows a "Board outline does not form a closed polygon" warning and the 3D render of the PCB doesn't show the cutout needed for the XLR connector.
View of PCB layout:
Close of up DRC error marker:
3D Viewer image of PCB: