Through-hole mount hole pad is on all layers instead of top/bottom (in multi-layer board)
Created by: StefanHamminga
Through-hole fastener pads appear on all layers instead of top/bottom when using mount hole footprints in a multi-layer board. I'm not sure if this is by design or not, but it's wasting a fair amount of space. An 'offending' footprint is for example this one:
If it's agreed this should be top + bottom only I can probably make up some Linux shell-fu to bulk convert any line like above into two lines for the top and bottom copper layers. Would this be preferred or a pull request?