Footprint Editor Lacks Edge.Cuts Layer (lp:#1251393)

Original report created by Stephen Pflanze (artist-wavenet)

I am designing a board with an edge connector the same as shown on the left
side of this board:
http://www.silabs.com/SiteCollectionImages/Misc/DebugAdapter.png

This edge connector is for plugging into a Silicon Labs ToolStick Base
Adapter:
http://www.silabs.com/Support%20Documents/TechnicalDocs/ToolStick-
BaseAdapter-UG.pdf

So I will not have to design this repeatedly for every board I need this
connector on, I am creating a module for it. In this module I will need to
define the edge of the board where this edge connector is to be. But the
Module Editor does not allow this because it lacks the option to put
graphic lines in the Edge.Cuts layer.

In the Module Editor I need to be able to put a graphic line in the
Edge.Cuts layer just as can be done in the PCB editor.

Original tags: feature.request pcbnew