Reconnect the camera fater switching the capture mode
Bug 22013 imported from GNA! bug tracker
Submitted by: ao2 on 2014-05-05 14:13:56
Hi,
I have a Canon Powershot A85, and in order to be able to use all the functionalities of my camera I have to switch to capture mode first (e.g. gphoto2 --set-config capture=1).
In entangle this means that I have to check the "capture" checkbox, and than re-detect the camera in order to have all the features available in capture mode listed:
- Check the "Capture" checkbox,
- Go to Camera->Disconnect,
- Go to Camera->Connect,
- Choose the camera from the modal dialog.
Do you think this can this be automated? The usb bus and device id do not change when switching the capture mode.
Thanks, Antonio