Bug: columns in water and discolouration of the ground.

Check off each item in this list before submitting:

1. Check the FAQ to see if your issue has already been reported and has a solution: Problems-and-solutions

2. Make sure you are not using any mods on the incompatible list: Mod support FAQ

3. Check the existing issues to verify that your bug hasn't already been submitted: Issues

4. Upload Minecraft's crash report and/or log.
   Minecraft crash reports are located in: .minecraft/crash-reports
   Minecraft logs are located in: .minecraft/logs

   latest.log

5. Upload your Distant Horizons Config.
   The config is found in: .minecraft/configs/DistantHorizons.toml

   DistantHorizons.toml

6. Fill out the information below:

• minecraft version: 1.21.11
• Distant Horizons version: 3.2.0-b
• Mod loader: Fabric 0.19.3
• Installed mods (list the smallest number of mods that you can use to re-create the bug): Distant Horizons
• Describe the bug:
  • When "Tint with avoided blocks" under the "Culling" setting is enabled, the ignored blocks that are placed in the air, and have a block above them, discolour the ground beneath them, and create columns from the bottom to the surface of the water, instead of tinting the surface they are one.
• Steps to reproduce the bug:
  • Make a 2*1 hole in the ground and place water in it, fly up until the ground disappears into the distant horizon render, place 2 dirt blocks side by side in the air, so one is above water, and one above the ground, place a blackstone button under both of them, then place pale oak signs on the side of the blocks, then place dirt blocks above each of the signs. Now make sure the DH lod is up to date (e.g. by going back and forth on the ground and above and then reloading the world) and then go high next to the blocks and look down at the ground, the bug will appear, if instructions are unclear, here is a video showing the setup, as well as the effect of the bug: https://reddit.com/r/DistantHorizons/comments/1vnpx51