[DESIGN] - Chip Holder Top Part redesign
After testing, it was determined that 3 temperature sensors will be necessary to the chip, as described below.
- One temperature sensor will be solder in the middle of one side of the ITO glass heater.
- Two other sensors will be solder at the opposing side of the ITO glass heater.
- ITO glass heater cables will exit the chip holder from the same side as the single temperature sensor.
After defining the procedures of the assembly of the non - functional mock - up and based on the above decisions, the below modifications to the chip holder top part are necessary:
-
Create 2
intrusions for the2
heater cables and1
intrusion for first temperature sensor cables on one side of the top part of the chip holder. -
Create 2
intrusions for the2
heater cables and1
intrusion for temperature sensor cables on the opposing side of the top part of the chip holder.
Edited by Stefanos Solomou