This project is mirrored from git://git.openwrt.org/openwrt/openwrt.git. Pull mirroring updated .
  1. 29 May, 2020 3 commits
  2. 28 May, 2020 23 commits
  3. 27 May, 2020 3 commits
    • Pavel Balan's avatar
      ath79: add support for COMFAST CF-E130N v2 · ad84c095
      Pavel Balan authored
      This patch adds support for the COMFAST CF-E130N v2, an outdoor wireless
      CPE with a single Ethernet port and a 802.11bgn radio.
      
      Specifications:
      
       - QCA9531 SoC
       - 1x 10/100 Mbps Ethernet with PoE-in support
       - 64 MB of RAM (DDR2)
       - 16 MB of FLASH
       - 5 dBi built-in antenna
       - POWER/LAN/WLAN green LEDs
       - 4x RSSI LEDs (2x red, 2x green)
       - UART (115200 8N1) and GPIO (J9) headers on PCB
      
      Flashing instructions:
      
       The original firmware is based on OpenWrt so a sysupgrade image can be
       installed via the stock web GUI.
      
       The U-boot bootloader also contains a backup TFTP client to upload the
       firmware from. Upon boot, it checks its ethernet network for the IP
       192.168.1.10. Host a TFTP server and provide the image to be flashed as
       file firmware_auto.bin.
      
      MAC address setup:
      
      The art partition contains four consecutive MAC addresses:
      
      0x0    aa:bb:cc:xx:xx:c4
      0x6    aa:bb:cc:xx:xx:c6
      0x1002 aa:bb:cc:xx:xx:c5
      0x5006 aa:bb:cc:xx:xx:c7
      
      However, the manufacturer in its infinite wisdom decided that one address
      is enough and both eth0 and WiFi get the MAC address from 0x0 (yes, that's
      overwriting the existing and valid address in 0x1002). This is obviously
      also the address on the device's label.
      Signed-off-by: default avatarPavel Balan <[email protected]>
      [fix configs partition, fix IMAGE_SIZE, add MAC address comment, rename
      ATH_SOC to SOC]
      Signed-off-by: Adrian Schmutzler's avatarAdrian Schmutzler <[email protected]>
      ad84c095
    • Adrian Schmutzler's avatar
      ath79: replace tab after DT label by space · 2b92ee36
      Adrian Schmutzler authored
      The common separator in this case is a single space.
      Signed-off-by: Adrian Schmutzler's avatarAdrian Schmutzler <[email protected]>
      2b92ee36
    • Adrian Schmutzler's avatar
  4. 26 May, 2020 11 commits