Commit a8ddd835 authored by Mark J. Blair's avatar Mark J. Blair

Added bottom mounting frame clearances for pins near board edges.

parent 238e17cd
......@@ -39,18 +39,18 @@ years, I finally decided to take on the project for
## Project Status
It is my stated goal
It was my stated goal
to work on this project during October, 2016 for
[Retrochallenge 2016/10](http://retrochallenge.org), but I do not
[Retrochallenge 2016/10](http://retrochallenge.org), but I did not
realistically expect to complete this project within a month.
As of October 31:
Latest status update:
* I have completed the design of the main controller PCB.
* I have also completed the design of a small bus terminator PCB.
* I have created a preliminary design for a 3D printable case.
* I have created a design for a 3D printable case.
* FPGA design not yet started.
......
This source diff could not be displayed because it is too large. You can view the blob instead.
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment