[New Device] SteelSeries Aerox 3 Wireless (2022)
Name of device:
SteelSeries Aerox 3 Wireless (2022)
Link to manufacturer's product page:
https://de.steelseries.com/gaming-mice/aerox-3-wireless-2022
Please select what type of device/interface the device uses:
ID information:
1038:183a SteelSeries ApS SteelSeries Aerox 3 Wireless (via USB wired cable)
1038:1838 SteelSeries ApS SteelSeries Aerox 3 Wireless (via USB wireless dongle)
This might be a duplicate of #2025 and/or #1847 (closed), although both of those devices have a different device ID. My ID was gathered using the supplied USB-C wireless dongle on Linux. The device capture linked below also has my device ID, maybe it is applicable to the other two tickets, maybe not.
Update: It is a duplicate, sorry. I did not check the ID when using the cable. Linked capture below still applies and should allow to provide the information for all three tickets. The mouse works without dongle when using a cable and without a cable when using the dongle. If both are attached I can also see both devices, although I'm not sure if the dongle is still active when the mouse is attached via wire.
Please attach screenshots of the device's official control application here:
Not available (Windows and MacOS only, https://steelseries.com/gg/engine).
Following the comparison table on the official page, all Aerox mice have three RGB zones, so the screenshots of other family members should be similar:
Aerox 3 Wireless #1847 (closed), Aerox 9 #3611 (closed)
Please attach device captures here:
https://github.com/gort818/aerox3-wireless/blob/main/aerox3-wireless.txt
Update: The mouse is supported by rivalcfg including LED control:
https://github.com/flozz/rivalcfg/blob/master/rivalcfg/devices/aerox3_wireless_wired.py https://github.com/flozz/rivalcfg/blob/master/rivalcfg/devices/aerox3_wireless_wireless.py
Checklist for Step2
-
Name of device -
A link to the vendors product page has been included -
The transport bus has been identified and the appropriate label added to the issue. -
The device ID's have been included for USB or PCI -
Screenshots of the OEM Application are included -
There is either, appropriate code examples linked or suitable device captures attached